With the development of economy, the dryer application scope also more and more widely, materials processing, are generally not running time is long, large quantity, this led directly to the dryer in use will be more or less during the operation of large and small problems, affect the normal use of equipment. The leak is the comparison of the dryer operation and problems of a common type. So, how to avoid and solve this problem? For you to put forward the following Suggestions:
(1) at run time, because do not clear in time, easy to cause some of the oil hole on the pipeline material pulp are blocked, leading to the inside of the tubing of oil pressure, oil ring of fuel injection quantity increase, ji yi splash into the internal and external equipment outside cause of a complete set of dryer oil leakage, therefore appear this kind of circumstance must be timely to finish cleaning equipment, dredge injection hole.
(2) injection, fuel injection valve, fuel injection quantity is big, the general situation of oil from the oil hole on device will be some machine shaft, told operation running at the same time, can lead to oil splash and drying quality and running of the equipment caused by the difficulty. Aimed at this situation, we must specially industry technical personnel for fine-tuning of the injection steps, the equipment to ensure that in the equipment under the premise of the normal spray lubrication and not lead to lack of oil and oil temperature effect on the equipment. Because there are some factors in lubrication dryer, because the oil was thrown about the leak of the whole equipment, oil ring to put an end to this kind of situation, the dryer set between oil and oil ring hole rubber sheet completely isolated from the oil spillage of events. Can also through the whole equipment parts replacement, increase the whole of the injection hole area, so that the oil shaft lubrication don't cause blockage of equipment and the oil leakage problem.